Vintage Air Install On Charger Project Begins!


Now that we have moved into assembly mode. The first area is the cowl and dash. I have the wiper transmission and pedals restored and installed. Now we are moving on to the Vintage Air installation. I marked and drilled the holes for the lines to go thru the firewall.  I have mounted the evaporator unit to the cowl/firewall. Next I mounted the condenser to the radiator support. The condenser was damaged in shipping. So this condenser will be used for mock up only. Then I ran my condenser hard and soft lines. Followed by heater hoses and control valve. 

 



Leave a comment

Comments will be approved before showing up.


Also in Projects

67 Dodge Charger "Back N' Black" Full Restomod    It's done!
67 Dodge Charger "Back N' Black" Full Restomod It's done!

67 Dodge Charger Project Rotisserie Restoration by Troy Kane @ Vtwinstov8s.com. Features Mopar Wedge Power with Holley Sniper Fuel Injection. Torqueflite transmission with a Gearvendors Overdrive. Mopar 8 3/4 Suregrip Rearend with 3.54 gears. Suspension is by Control Freak up front and Riley Motorsports in the rear. Features Viking coil over shocks all around. Wilwood Disc brakes up front and MBC discs in the rear. Rack & pinion steering. Sway Bar up front.

Read More

67 Charger Protouring as featured in Hotrod Magazine
67 Charger Protouring as featured in Hotrod Magazine

Read More

64 Imperial Project Stripped
64 Imperial Project Stripped

Read More